Corrotech / Products / Coatings / Special coatings / CORROCOAT Fluiglide E

CORROCOAT Fluiglide E

Product Number

CTFLECOR1

CTFLECOR5

Cold cured epoxy with 100% dry solids, providing a highly smooth and high quality finish reducing the surface roughness profile. CORROCOAT Fluiglide E has a good gloss with a waxy appearance and a smooth surface after curing. The purpose of the material is to reduce fluid friction and increase the flow in the boundary layer of hydraulic parts, e.g. pumps, thereby reducing power requirements and increasing plant efficiency. Detail description

Hue

bílá

CONSUMPTION CALCULATOR

applied area

m²

layer thickness (DFT)

μm

application losses

practical consumption

liters

Variants

1l 5l

Detailed description

The purpose of the material is to reduce fluid friction and increase the flow rate in the boundary layer, thereby reducing the power requirements and increasing the equipment efficiency of hydraulic parts, e.g. pumps. This applies both to reducing fluid transmission losses through pipes and channels and to increasing the efficiency of fluid propulsion systems. CORROCOAT Fluiglide is a surface coating system for application on pre-prepared surfaces. The adhesion and corrosion resistance properties of Fluiglide are themselves relatively poor and should therefore only be used on specified primers. Available shades: white.

CORROCOAT is a world-leading brand in corrosion protection technology with its own research and development of materials. The company was founded in 1975 in the United Kingdom and operates on six continents through a network of more than 35 licensed partners. In many countries around the world, CORROCOAT materials are specified as the industry standard. CORROCOAT uses innovative mechanical engineering combined with corrosion protection technology to ensure long-term protection for both new and damaged equipment. Thanks to a focus on quality, the developed processes are a proven, cost-effective solution that enables long-term success in the fight against corrosion. Learn more about the product at www.corrocoat.cz.

Technical data

Manufacturer: Corrocoat

Temperature limit for diving: 90°C dependent on concentration and type of chemical environment

Temperature limit outside the dive: 110°C

Recommended dry film thickness: minimum 500 microns in two layers

Dry matter content: 100%

Activator type: aliphatic polyamide

Mixing ratio: base : activator 2 : 1 (weight ratio)

Available shades: white

Downloads

04-05-FLUIGLIDE-E-UL.pdf Download

CORROCOAT-KONCEPCE-STROJNIHO-INZENIRSTVI.pdf Download